Our Industry

You deserve the best!!

All concrete resurfacing companies have similar products that they claim produce the same end result. It is important to understand, however, that resurfacing products can be similar in composition but very different in the manner in which they are applied. This is what makes EnviroDek different - and better - than the rest. With EnviroDek's installation you get:

  • A FREE written estimate which clearly explains what you have been offered and the final cost
  • A detailed explanation of what, if any, repairs need to be made prior to application
  • A 3000 P.S.I pressure wash for all surfaces to be covered
  • A masking off of protected areas.
  • The 5- Step EnviroDek Application System on existing concrete.
    Preparation is most important and always the key.

This is how we install EnviroDek, and we believe there is no better way!

Understanding the process

Product Description

We use CEMTEC Concrete repair product. CEMTEC ONE STEP SPRAY TEXTURE is a single component decorative concrete system consisting of pre-blended cement, aggregate and polymers. ONE STEP requires only the addition of water for blending. The product can be troweled or sprayed horizontally or vertically onto existing concrete, cement board, concrete blocks or brick. The product can be integrally tinted by using pre-measured pigment pack and/or stained with a pigmented sealer to create a variety of colors and patterns.

Surface Preparation

All surfaces must be clean and free of dirt, dust, paint, sealers, form release, curing agents, grease, oil or anything that would inhibit mixed material from coming into contact with the open pores of the substrate. Any anti-adherent must be removed mechanically. Pressure washing, sand blasting, water blasting, grinding & shot blasting are a few good methods of removal. On existing surfaces not burdened with these anti-adherents, pressure washing coupled with acid etching should be considered; especially on smooth, steel troweled or formed concrete. Saturate the substrate with water and allow to absorb. Blow or broom off any puddled water before application. This will give you a saturated, surface dry (SSD) substrate.

We take great care to protect surrounding surfaces by using and bubble wrap and over spraying paper and Coping Expansion Joints Mastic-Caulking.

Product Application

We mix and apply a skim coat to the SSD prepared substrate with a trowel or squeegee and allow the skim coat to dry. When skim coat drys, we mix and spray desired patterns and trowel over to knock down peaks as needed. Allow resurfaced concrete to dry for 24 hours and then apply 2 coats of Acrylic Sealer.

Why Envirodek?

EnviroDek is committed to establishing a reputation as the most efficient and effective concrete resurfacing company in our industry. Because every job we undertake is vital to achieving that goal, we share a strong mutual interest with our customers in the success of their projects. We believe this is the key to creating lasting and positive working relationships. EnviroDek understands that ultimately proof lies in performance; and, given the opportunity, we deliver that performance with distinctive, high quality, concrete resurfacing. Our customers are our reputation!

  • Over 20 years experience
  • Fully Insured including Workers Comp
  • General Liability provided under Contract